Carbon steel units are
painted with blue enamel unless otherwise specified. Food grade white epoxy and hi
temperature inorganic carbon/zinc primer are optional interior unfinished.
Standard stainless steel
will be supplied with mill finish (only contact parts will be considered), welds are not
typically ground smooth, base plates and guards will be supplied in stainless steel. Base
plates can include an optional stainless steel lined through hole. Bearings, motors
and gear reducers will be supplied with factory finish to provide original warranty.
Sanitary style units will be
polished to 120 grit interior. All welds inside
will be ground smooth, continuous, free of pits and crevices. Base plates and guards
will be stainless steel.
All sanitary units will
include air purge shaft seals.
All crushers will include a
230/460/3/60 TEFC 1800 rpm motor with a belt or chain drive- direct drives are available
with gear reduction for severe applications. All drives are mounted on the right side,
motors are mounted inward (left angle), unless otherwise specified.
All dual rotor crushers with
a mounted motor will include an oil box (oil dip for spur gears) on 10 hp motor and
larger. Double bearing support will be included as part of this package (2 bearings drive
side, 4 bearings non-drive side).
Dual rotor crushers require
a breaker bar or screen.
Infeed hoppers with safety
baffles are optional.
Support stands are optional.
When stainless is specified, the base plate will also be stainless steel or a carbon steel plate with a stainless steel lined through hole can be offered.
Starters are optional-
panels are offered in type 12, 4, and 9 enclosures and are shipped loose.
On powder applications,
venting and/or dust collection should be considered.
One (1) manual will be
included with the machine
